Advertisement
3
INSTALL THE LENS. (See figure-4,5.)
1. Mount the lens at the lens
mounting bracket with screws
(4 screws) included with the
lens. Use the driver included
with the lens to fasten the
screws . (After using, save it for
latter use.)
2. Connect the lens motor lead to
the connector "K16B" of the cir-
cuit board.
3. Fasten the lens motor lead at
the A, B points with wire holder.
4
MOUNT THE LENS COVER. (See figure-1)
When in install the both upper and lower lens covers,
put the light-block sheet through the lens and install
the sheet so that it should be placed in the guide slot
of the lens cover. If the installation of the light-block
sheet is incorrect, there will be the space between
lens and the lens cover, so that it will be the cause of
leakage of light or the dust entering at the main cab-
inet.
ATTACHED DRIVER
LIGHT-BLOCK SHEET
❋ Figure shown inside of the cabinet.
(D)
CONNECTOR " K16B "
LENS MOUNTING BRACKET
LENS MOTOR
(D)
(D)
(D)
B
A
WIRE HOLDER
This part wiring should
not be tightened.
LENS
MOTOR LEAD
Fig-4
Fig-5
Advertisement
