O2 HomeBox 6741 Quick Start Manual

Quick start guide
œ HomeBox 6741
Detailed information
You will find detailed information about setting up and configuring your o2 HomeBox 6741
under http://o2.de/hilfe/o2homebox2.
How to contact us:
On the internet:
www. dsl.o2.de
Contact options:
www.o2.de/kontakt
By phone:
+49 (0)89 78 79 79 400*
+49 (0)176 888 55 222*
* Tariff for calls made to German landlines and mobile networks applies
Open Source Licence Notice
This product contains software that is licensed under Open Source Code Licenses and is provided to you under the terms of these
licenses. A copy of the licence text can be found in the user interface of the device in the main menu under A-Z / Legal Information
and on the Internet at http://www.askey.com.tw/germany_o2/. Within 3 years from the date the licensed product is marketed, you
can obtain a complete machine-readable copy of the source code by contacting us at askey-gpl-o2@askey.com.tw.
Applicable European regulations: This product has been designed, tested and manufactured in accordance with European Directive 2014/53/EU.
The O2 HomeBox 6741 is a device of class 2 and may only be operated in Germany. In all other countries the operation of this product is not
permitted. The EC Declaration of Conformity can be found at http://www.askey.com.tw/germany_o2/.
Telefónica Germany GmbH & Co. OHG, Postfach 60 09 40, 22209 Hamburg
101778 01/18 v.3.1
Do you need help with the installation?
Scan the QR code or visit our website under http://o2.de/
hilfe/o2homebox2 to take a look at the installation video for
the œ HomeBox 6741.
Note: After setting up the router, also
install the Service Suite from our website.
The complimentary O2 software provi-
des you support with Internet access and
optimises your WLAN connection
Safety instructions
Important: Please read these instructions carefully before use
and keep them in a safe place for future reference. Please hand
this guide to any new owner of the device.
WARNING: The electric voltage present at mains,
telephone and network cables connections is dangerous!
Failure to observe the safety instructions can lead to
hazardous situations which can result not only in high
material or property damage, but also in severe injuries
or death.
• The device must not be opened.
• Do not install the device or connect or disconnect any line
connections during a thunderstorm.
• Operation is only permitted for dry rooms within closed
buildings.
• The power outlet must be located near the unit and must
be easily accessible.
• Lay the cables so that no one can step on them or trip
over them.
• Do not allow liquids to enter the inside of the unit, as this
may cause an electric shock or a possible short circuit.
• Avoid direct sunlight.
• Before drilling, make sure that there is no building installation
at the drilling point. Damage to gas, electricity, signal or water
lines may result in life injuries or property damage.
• The device may only be operated with the power supply unit
UH0301P-12PE/ KSA23G1200250VE.
LED Signal Status
Power Flashing System is starting up
Lights up constantly The system has started and is operating
Power supply disconnected or general
Off
equipment fault
The unit's software is updating; unit is
Lights up continuously
restarting or resetting
LAN Flashing Transferring data
Lights up constantly Active connection
Off No active connection
WLAN Flashing quickly Transferring data
Lights up constantly WLAN active
Flashing WPS activated
Off WLAN not active
DECT Lights up constantly DECT function on
Flashing DECT scanning for new unit
Off DECT function off
DSL Flashing slowly Pilot signal transmitting
Flashing quickly The oe HomeBox 6441/6741 is being synchronised.
Lights up constantly DSL connection successfully established
Off œ HomeBox receives no DSL signal
Internet Flashing Transferring data
Lights up constantly Internet connection established
Faulty access details
Flashing quickly
(e.g. incorrect PIN)
Phone Flashing Active call
Lights up constantly Active line
Off Line not active
Info
Flashing quickly Authentication in progress
PIN OK; oe phone connection established; when
Lights up constantly the unit has completed registration with oe, the
Info LED will disappear
1. œ HomeBox is waiting for a PIN to be entered
2. Incorect PIN, waiting to re-enter PIN
Lights up constantly
3. Maximum authentication attempts
(5 times) reached
Flashing quickly PIN OK; waiting for authentication
We appreciate that you have opted
for œ and hope that you will now
enjoy the many benefits of your
new DSL connection.
What's in the box?
œ HomeBox 6741
LAN cable (yellow)
DSL connecting cable (grey)
Power adapter
Your œ Homebox 6741 in detail
LAN DECT Internet
LED view
Power WLAN DSL Phone
Rear side
WLAN/WPS
and DECT
buttons
USB (e.g. printer
WAN or HDD) Reset
DSL LAN 1–2 Power On/Off switch
USB connection on the side
e.g. USB storage devices
Info