Battery Removal And Installation - Jungheinrich EJC B14 Operating Instructions Manual

5

Battery removal and installation

WARNING!
Accident risk during battery removal and installation
Due to the battery weight and acid there is a risk of trapping or scalding when the
battery is removed and installed.
Note the "Safety regulations for handling acid batteries" section in this chapter.
Wear safety shoes when removing and installing the battery.
Use only batteries with insulated cells and terminal connectors.
Park the truck on a level surface to prevent the battery from sliding out.
Make sure the crane slings have sufficient capacity to replace the battery.
Use only approved battery replacement devices (battery roller stand, replacement
trolley etc.).
Make sure the battery is securely located in the truck's battery compartment.
Removing the battery
Requirements
– Park the truck securely, (see "Parking
the truck securely" on page 44).
– Expose the battery, (see "Exposing the
battery" on page 32).
Procedure
• Disconnect the battery connector from
the truck connector.
Z
Place the battery cable on the tray so that
it cannot be severed when the battery is
pulled out.
• Strap the crane lifting gear to the
eyes (46).
Z
The crane lifting gear must exert a vertical pull. The hooks of the lifting gear must
never fall into the battery cells.
• Pull the battery up out of the container.
Z
Installation is the reverse order. When reinstalling the battery, note the proper
installation position and make sure the battery is connected correctly. Place the
battery cable on the tray so that it cannot be severed when the battery is inserted.
– After installing the battery, check all cables and plug connections for visible signs
of damage.
46
35