Panasonic ET-PKD120H Installation Instructions Manual page 14

Adjusting the installation angle (continued)
■ If the picture is tilted to the right or left (horizontal tilt adjustment)
Adjustment
range ± 5°
Loosen three captive
washer hex head bolts
each at the front and rear.
Attention
z After checking the position adjustments, check that the screws have been tightened to the torques specified on
page 6.
Note
z If there is a keystone effect in the image even after adjusting the installation angle in the [POSITION] menu
of the projector without applying keystone correction, the positional relationship between the screen and the
projector is out of alignment. Check that the screen and projector are aligned opposite each other. Alternatively,
perform the keystone correction at the projector.
z The wire rope is not shown in the illustration.
14 - ENGLISH
Adjustable span
z Adjust to the position where the picture is not tilted
by loosening the captive washer hex bolts fixing the
projector mount bracket and the angle adjusting
bracket (three locations in front and rear), and
rotating the projector.
z Once the picture position has been set, be sure to
retighten the bolts securely.
Attention
z Do not over-loosen the captive washer hex
head bolts, which are used to secure the angle
adjusting bracket to the projector mount bracket.
Otherwise, the projector may fall off.