Classeq G350 Engineer's Manual page 26

Engineers manual
E10
Salt missing
Display
E11
communication
failure
E12
Wash tank fill
Rinse tank fill
E13
timeout
E14
Door switch
E15
Paddle flow sensor
E16
Wash tank overfill
E17
Filter mesh blocked
Rinse tank
E18
temperature
exceeded
Wash tank
E19
temperature
exceeded
E20
Power interruption
E21
EEPROM Error
Under counter machines
Only in machines with water
softener fitted.
Salt level in reservoir is low
for 30 seconds.
No signal from the user
interface unit.
Wash tank has not filled
within the required number of
transfers.
Rinse tank has not filled
within 5 minutes.
Door switch has not changed
position for the past 20 cycles
Only in machines with water
softener fitted.Paddle sensor
in air gap is not responding
during the fill stage.
Wash tank has reached the
flood risk level.
Water level in wash tank has
been reduced to below
minimum required level
during a wash cycle.
Rinse tank temperature has
exceeded the safety limit.
Wash tank temperature has
exceeded the safety limit.
Power to machine has been
interrupted.
EEPROM failed
Page 25
No salt in reservoir.
Salt reed switch failed.
User interface not correctly
connected.
User interface failed.
Drain plug not inserted.
Machine leaking.
Very low water pressure
(pressurised machines).
Water supply not connected
or turned on.
Very low water pressure.
Solenoid valve failed.
Door switch failed.
No water supply.Paddle
sensor failed.See P05 to
assist.
Site drain blocked.
Machine waste hose blocked
or kinked.
Solenoid failed open.
Drain pump failed.
Wash arms blocked.
Wash pump blocked.
Wash filters blocked.
Container in wash tank
collecting water.
Rinse tank temperature
sensor disconnected.
Rinse element relay fused.
Main board relay fused.
Rinse element wired
incorrectly.
Wash tank temperature
sensor disconnected.
Main board relay fused.
Wash element wired
incorrectly.
Machine isolated from power
supply.
Power failure.
Main board failed