Service Mode - Fresenius Medical Care 2008T Operator's Manual

Appendix E

Service Mode

Note: This section describes features in Service Mode. It is strongly recommended that you
contact a qualified service technician if any Service Mode changes must be made.
Note: Beginning in functional software version 2.70, the fourth Service Mode screen button
from the left is displayed as Maint. instead of Calibrate Monitor.
Appendix E provides instructions on different features and options set in Service Mode. This
section is organized by screens and includes the following:

Treatment Options, page 303

Hardware Options, page 308

Default Settings, page 311

Auto Heat Disinfect (functional software version 2.69 or earlier), page 314

Enter Conc: Selecting and Adding Concentrates, page 316

UF Profile: Creating Custom UF Profiles, page 321

Module Options, page 322

Scheduler Screen features, page 324
o Auto Heat Disinfect (functional software version 2.70 or later), page 326
o Auto Start (functional software version 2.70 or later), page 328
o CDX Auto On (functional software version 2.70 or later), page 330
o PM (Preventive Maintenance) Reminder, page 331
o Diasafe Maintenance Reminder, page 334

Other Options, page 336

Testing the Dialysate, page 337

Equipment Storage and Maintenance, page 339

Machine Specifications, page 340

Manufacturer's EMC Declaration, page 352

Product Improvement Policy, page 356

Warranty, page 356
For a description of Service Mode calibration procedures, see the following documents:

2008T Technicians Manual (P/N 490130)

2008T Calibration Procedures Manual (P/N 508032)

2008T Preventive Maintenance Procedures Manual (P/N 508033)
302 2008T Machine Operator's Manual P/N 490122 Rev Q