Table of Contents
Advertisement
Anynet+
Using Anynet+(HDMI-CEC)
1
Connect the AV receiver to a Samsung TV with an HDMI cable. (See page 15)
2
Set the Anynet+ function on your TV. (See the TV instruction manual for more information.)
•
You can operate the AV receiver by using the TV remote control.
(Available TV button : VOLUME
,
button.)
If you select TV
Set the Anynet+(HDMI-CEC) function to <On> on your TV.
•
Receiver : On : You can listen to audio through the AV Receiver.
•
Receiver : Off : You can listen to audio through the TV.
MOVE
ENTER
EXIT
MOVE
ENTER
EXIT
If you select the DVD Player
Select THEATER to connector and set the option of each items below.
•
View TV : If Anynet+(HDMI-CEC) set to on and you select View TV, the AV receiver will
automatically switch to SAT OPTIC2(DIGITAL IN).
•
Receiver : On : You can listen to audio through the AV receiver.
•
Receiver : Off : You can listen to audio through the TV.
MOVE
ENTER
EXIT
To turn off Anynet+
1 Press SETUP/MENU button, and then press the ENTER button.
"SETUP MODE" appears on the display and goes into Setup Mode.
•
2 Press
œ √
button to select the "ANYNET+ MODE", and then press the ENTER button.
3 Press the
...†
button to set ANYNET+ to OFF.
- If you are using Anynet+, set ANYNET+ to ON and if not, set it to OFF.
To exit setup mode
Wait for about 5 seconds or press SETUP button.
•
"SETUP OFF" appears on the display and Setup Mode is exited.
• When selecting View TV, you must have a digital optical cable connected
from the TV to the AV receiver to listen to the TV sound through the AV
receiver.
• When you are making Anynet+ connection, do not connect more than two AV receivers
Caution
(Anynet+ installed). Otherwise, it can cause a malfunction.
With Anynet+
You can operate this unit, power on your TV, or watch a movie by pressing the Play button on
your Samsung TV's remote control.
16
Connecting external devices
(Cont'd)
Connecting AUX components
You can connect external devices you use (camcorder, game console, mobile equipment,etc.) to the front of this unit for
convenience.
Connecting the FM antenna
FM antenna (supplied)
FM antenna connection
1. Connect the FM antenna supplied to the FM 75 COAXIAL terminal as a temporary measure.
2. Slowly move the antenna wire around until you find a location where reception is good, then fasten it to a
wall or other rigid surface.
Camcorder
ENG
17
Advertisement
Table of Contents
