Samsung product. Class II product : This symbol indicates that a safety connection to electrical earth (ground) is not required. If this symbol is not present on a product with a power cord, the product MUST have a reliable connection to protective earth (ground).
Page 3
• To protect this apparatus from a lightning • Contact an authorized service center for storm, or when it is left unattended and information if you intend to install your unused for long periods of time, unplug it from product in a location with heavy dust, high or the wall outlet and disconnect the antenna or low temperatures, high humidity, chemical cable system.
Page 4
• Reorienting or relocating the receiving Responsible Party - U.S. Contact Information: antenna. Samsung Electronics America, Inc. • Increasing the separation between the 85 Challenger Road. equipment and receiver. Ridgefield Park, NJ 07660 •...
1. Read these instructions. 2. Keep these instructions. approved recycler. To find the nearest recycling 3. Heed all warnings. location, go to our website:www.samsung.com/ 4. Follow all instructions. recycling Or call, 1‐800‐SAMSUNG 5. Do not use this apparatus near water.
/ One Mount Type) (AH61-04176A) • The Wireless Dongle is only compatible with Samsung Soundbars. For a list of compatible Samsung Soundbars, see page 12. Do not connect the dongle to any other devices, such as smartphones, desk-top PCs, or notebook PCs.
Page 7
NOTES – Samsung Electronics Co., Ltd reserves the right to change the specifications without notice. – Weight and dimensions are approximate. – For more information about the power supply and power consumption, refer to the label attached to the product.
Page 8
2. Check the standby status after plugging into an electrical outlet Plug the Wireless Receiver Module power cord into an electrical outlet and into the Wireless Receiver Module to turn on the Wireless Receiver Module. The LINK LED indicator (blue LED) on the Wireless Receiver Module blinks.
Page 9
3. Connect the main unit of the Soundbar to the Wirless Dongle Connect the wireless dongle to the “WIRELESS” port on the Soundbar main unit. • When inserting the Wireless Dongle into the holder, make sure that the “WIRELESS” logo is facing up, as shown in the pictures below.
Page 10
4. Turn off the Soundbar Turn off the Soundbar using the Soundbar’s remote control or by pressing the (Power) button on the main Soundbar unit. • The image of the Soundbar may differ from your Soundbar, depending on the model. 5.
Page 11
LINK LED indicator blinks (in Blue). STANDBY (Red) Connection failure 5 Sec ID SET SURROUND SPEAKERS OUT SPEAKER IMPEDANCE : 3 ID SET 2. Repeat steps 4 through 7. Others Errors Contact a Samsung Service Center. POWER ENG - 11...
CAUTIONS • If you have connected your Soundbar and one or more Samsung Wireless Speakers via a wireless router: Disable the surround sound for the Soundbar and Samsung Wireless Speaker, and then install and use the SWA-9000S. • If you connect the SWA-9000S and do not disable surround sound as described above: Sound will be played via both the Samsung Wireless Speakers and the SWA-9000S’s surround...
LIMITED WARRANTY TO ORIGINAL PURCHASER This SAMSUNG brand product, as supplied and distributed by SAMSUNG and delivered new, in the original carton to the original consumer purchaser, is warranted by SAMSUNG against manufacturing defects in materials and workmanship for a limited...