Table of Contents
Advertisement
4
Installation > Installation Procedure
21)
Install the Cable Cover.
• 1 Claw
• 2 Protrusions
Claw
Protrusion
22)
Install the Internal Rear Right Cover.
• 1 Screw (RS Tightening; M3x8.5)
• 3 Protrusions
Protrusion
23)
Open the Front Cover.
24)
Install the removed Front Upper Cover (with 2 screws).
4
Installation > Installation Procedure
F-4-24
Protrusion
F-4-25
25)
Install the Side Cover (Left).
• 2 Screws (Use the screws removed in step 3.)
• 3 Hooks
Hook
x2
26)
Clean the affixing side with lint-free paper moistened by alcohol.
27)
Remove the release paper of the Knob, and install the unit to the Waste Toner Cover.
NOTE:
•
Be sure to install the
to enhance the installability of the Waste Toner Container.
Knob
•
The location to affix Knob
should match edges [A] and 15 + / - 3mm from [B] of the West
Toner Cover.
Release paper
28)
Close the Right Upper Cover and Right Lower Cover.
Hook
Hook
F-4-26
15 +/-3mm
[A]
[A]
[B]
[A]
F-4-27
4-9
4-9
Advertisement
Table of Contents
