User Settings - Turnigy Accucell-6 User Manual

13、User settings
Safety Timer
ON 240min
Batt type
Start
Stop
Enter
Capacity Cut-Off
ON 10000mAh
- +
STATUS
Te m p C u t - O f f
8 0 ℃ 1 7 6 ℉
O N
- +
STATUS
Temperature Unit
Fahrenheit
- +
STATUS
Rest Time
CHG>DCHG 5min
- +
STATUS
In the open state, when the charger starts to work, the
safety timer automatically starts the timer at the same
time. If the system is wrong or the system can't check
the battery capacity is full, this setting can prevent the
battery from overcharging. Safe time should meet the
time required for battery charging saturation.
The program sets up the maximum charge capacity and
will be provided to the battery at the time of charging. If
the peak voltage is not being detected, or the safety
timer stops, the program will terminate the charging
process automatically if capacity value already selected.
There is a 3 row needle socket on charger left side for
temperature sensing, the pin in middle row is for
temperature sensing port, you can select this function
on the screen, then insert temperature sensor into this
socket, and put the temperature sensor fitted to the
surface of the battery to monitor the temperature of the
battery. When the monitoring temperature exceeds the
set value, the charger will stop charging / discharging to
prevent the battery from overheating damage or other
serious consequences.
Temperature unit choose F or C.
Battery cycle charging and discharging. After
charging/discharging, the battery get warmer. You can
set a time delay program after each charging and
discharging process to leave the charger enough time to
cool the battery before start the next program. Time
range can be 1~60 minutes. You can set the trickle
charging mode to turn on or off. When turn on, after the
fast charging is finished, the charger will automatically
turn down the charging current until fully charged, and
the battery will not overheat.
18
- -