Drayton 13616 User Manual

+
Digistat CRF
Models:
The range may be affected by
13616/13618/13619
composition/density and number of walls
between the Digistat +CRF and SCR
Technical Helpline: +44 (0) 845 130 7722
www.draytoncontrols.co.uk
Email: customer.care@draytoncontrols.co.uk
+
Digistat C SCR
ON
RECEIVE / ALARM
2
OVERRIDE
LEARN
MODE
1
Wireless System
230V a.c.
DHW Cylinder Thermostat
30cm Min
BOILER
230V a.c.
SCR
Radio Signal Range:
30m Typically
Preferred side of boiler
Boost 1 Hr
Digistat+C RF
Digistat+C RF
Digistat+C RF
Digistat+C RF transmitter unit and sensor can be installed.
When the sensor is wired to the transmitter unit, the display will
change after approx. 30 seconds to show the current setpoint and
'E2' will disappear
Heating
To assist with commissioning or checking the system operation,
there is a positive OFF setting outside the temperature scale on the
cylinder thermostat. First adjust the minimum temperature setting
to 40 o C as described in the user guide, then rotate the dial fully
anticlockwise for OFF.
Digistat+C RF
'Boost 1 Hr'
Digistat+C RF
Digistat+C RF should now display the 'E2' and the RF symbol ' '. If
Digistat+C RF
Digistat+C RF
Digistat+C RF
the
06490084001 ISS H
+
Digistat CRF
Models:
13616/13618/13619
Technical Helpline: +44 (0) 845 130 7722
www.draytoncontrols.co.uk
Email: customer.care@draytoncontrols.co.uk
Default Settings
The maximum and minimum setpoints are preset in the factory to
65
Simple Setting or Operating
To set the required temperature
• The display normally shows the current setpoint.
• To adjust the required temperature, turn the
dial clockwise to increase or anti-clockwise to
decrease, (1 click = 5ºC), the LCD will display
the temperature setpoint as it is being
adjusted and 'SET' will be displayed. After a
few seconds the display will return to normal
operation and will display the current setpoint.
o o
C and 60 C respectively.
06490084001 ISS H