Configuring Snmp Settings; Snmp Options - HP HPE iLO 5 User Manual

• SuSE Linux Enterprise Server 12 and Red Hat Enterprise Linux 7—Enter the following
command: systemctl enable amsd_rev; systemctl start amsd_rev.
• SuSE Linux Enterprise Server 11 and Red Hat Enterprise Linux 6—Enter the following
command: service amsd_rev start.
• Ubuntu 14—Enter the following command: sudo systemctl enable amsd_rev; sudo
systemctl start amsd_rev.
• Ubuntu 12—Enter the following command: sudo service amsd_rev start.

Configuring SNMP settings

The settings you configure on this page are for the default Agentless Management and AMS
configuration. If you use the System Management Assistant and an OS-based SNMP service, similar
settings must be configured on the host.
Prerequisites
Configure iLO Settings privilege
Procedure
1. Click Management in the navigation tree.
The SNMP Settings page is displayed.
2. Enter the following values in the SNMP Settings section:
• System Location
• System Contact
• System Role
• System Role Detail
• Read Community
• Trap Community
• SNMP Alert Destination(s)
The SNMP Port value is read-only on this page. You can change this value on the Access Settings
page.
3. To save the configuration, click Apply.
More information
System Management Assistant on page 275

SNMP options

• System Location—A string of up to 49 characters that specifies the physical location of the server.
• System Contact—A string of up to 49 characters that specifies the system administrator or server
owner. The string can include a name, email address, or phone number.
Configuring SNMP settings 279