Hitron CODA-4582 Quick Start Manual

QUICK START GUIDE
HITRON
CODA-4582/ 4682/ 4782

Connect to the network

Set up your wireless network

Connect to a Cable Outlet
STEP
Use a coaxial cable (not included) to connect the device' s CABLE
2
connector to a cable outlet.
Connect to an Ethernet-Equipped Device (Optional)
STEP
Use the Ethernet cable provided to connect one of the LAN ports
4
to an Ethernet-equipped device.
Connect with Wireless Devices (Optional)
STEP
Connect your wireless devices with the correct S S ID and Passphrase.
6
If you have not changed them, the default values are indicated on
the sticker on the back of the unit.
Connect your wireless devices with the WiFi
Protected S etup (WPS ). Access the configuration
interface (see step 5), enter the Wireless page
to enable WPS and set Encrypt Mode to AES ,
then press S ave Changes.
Press this button to begin the WPS Push-Button
Configuration (PBC) procedure. Press the PBC
button on your wireless clients in the coverage
area within two minutes to enable them to j oin
the wireless network.
Check the Box Contents
STEP
Read me
1
first!
CODA-4582/ 4682/ 4782
The Hitron CODA-4582/ 4682/ 4782 is an application gateway that provides
wired and wireless high-speed Internet access as well as optional MoCA
(Multimedia over Coax Alliance) networking to the Ethernet-enabled
devices in your home for a fast and easy home entertainment network.
Connect to a Power Outlet
STEP
3
User Configuration (Optional)
STEP
5
Setup Complete
STEP
7
IP Addresses
If t he CODA-4582 is successfully connect ed t o t he net work (see LED Display)
but you cannot access t he Int ernet from a connect ed comput er, your
comput er' s IP Address may be set up improperly. In your comput er' s
net work set t ings, ensure t hat it is configured t o eit her receive an IP
address aut omat ically (recommended) or t hat it has a st at ic IP address in
t he 192.168.0.10~192.168.0.254 range. For more informat ion, consult your
operat ing syst em' s Help document at ion.
Look in the box and make sure you have the following:
POWER CORD ETHERNET CABLE
Use the power cord provided to connect the POWER port to a power
outlet.
In a web browser, enter 192.168.0.1 in the address bar followed by
Username and Password, as below.
Congrat ulat ions! You have successfully set up your CODA-4582/
4682/ 4782.
If you have any problems, see t he sect ion below for help in
ident ifying t he cause.
QUICK S TART GUIDE
c usa dm in
pa ssw ord