Filament Installation - Anet A9 User Manual

Installation of filament
1. First preheat the nozzle:
Enter the menu from Quick settings"
to "Preheat PLA(ABS)
3.
Keep feeding the
filament till the nozzle
spin.
2.
Insert the filament to
the extruder( or push the
filament into it by hand)
and control the rotation
of the extruder. Make the
filament get to the nozzle.
Warning:
1.Make sure the clipper is not too loose or tight, otherwise the
filament feeding will cause printing trouble.
2. Check if the filament twists or knots after the filament is
installed. Make sure the filament feeding smoothly.
3.Lubricate X,Y axis and sliding block to avoid being stuck.