Pairing With The Uh8-Rf Wiring Centre - Heatmiser neoAir Instruction Manual

Pairing With the UH8-RF Wiring Centre

Section Header
On the UH8-RF, take note of the numbers set on the rotary switches (UH8-RF ID numbers
01-99).
Each UH8-RF on the system needs to have a different ID number.
Set your first UH8-RF to 01
At the thermostat:
• Use the Left/Right arrow keys to scroll to SETUP and press tick key once ...............
• The display will now show 01 in the top right hand corner.
• Press the Down key twice so that P2 shows on the display .........................................................
• Press Tick once ...................................................................................................................................................
• Use the Up/Down arrow keys to set the large digits to the board address of the UH8-RF.
This is the number set on the UH8-RF rotary switches ...........................................................
(You must set a unique board address for each UH8-RF installed).
• Press Tick once. Small digits in the top right hand corner of the display will
now flash ..............................................................................................................................................................
• The UH8-RF is an 8 zone receiver. Use the Up/Down buttons to select the zone
this thermostat should be linked to ...............................................................................................
• Press Tick to select zone type (Radiators or Underfloor Heating) ..............................................
• Use the Up/Down buttons to select either: RA = Radiators or
UF = Underfloor Heating .....................................................................................................................
• Press Tick to finish and confirm settings. Display will return to the main screen ...............
13
Series
Example: Rotary Switch showing ID No. 99.