Usb; Trackball Connections; Es6 Keyboard. View Of Usb, Ps/2 And Rs232 Connectors; Es6 Keyboard. View Of Configuration Switch - Transas NAVI-SAILOR 4100 ECDIS Installation Manual

Workstations Installation

USB

Pointer data from CAN-bus and PS/2 device port will be transferred to USB port if
node number 0 is set and no PC is connected to PS/2 mouse port.
Keyboard data from CAN-bus and keyboard matrix will be transferred to USB port if
node number 0 is set and no PC is connected to PS/2 keyboard port.
Fig. 3. ES6 keyboard. View of USB, PS/2 and RS232 connectors
Fig. 4. ES6 keyboard. View of Configuration switch

Trackball Connections

The ES6 Trackball can be connected using the CAN Interface to a CAN master
(the ES6 keyboard) or using the USB Interface to connect to a computer’s USB Host.
Switch 4 on the DIP-Switch is used to set CAN (switch OFF) or USB (switch ON)
interface active. Switch 1–3 set CAN node address (must be in range 1–7).
USB uses a USB-B contact to connect to the USB Host and CAN uses a 4-pin
Phoenix contact for CAN-Bus IN (supplied 5 VDC) and a 3-pin Phoenix contact for
CAN-Bus OUT.
It is possible to supply power by USB port even if CAN interface is selected.
Both ends of the CAN network must be terminated with 120 ohm resistor.
14 NAVI-SAILOR 4000/4100 ECDIS (v. 2.00.009). Installation Guide