Hardware Fault Codes; Fatal Error Codes - Acorn Superglide 130 User Manual

DIGITAL DISPLAY CODES
NORMAL - Battery low
Bring the unit down to the nearest charging station. The unit
won't allow the user to travel in the UP direction until the
batteries are sufficiently charged and the code has cleared.
NORMAL - Key switch off
Key switch is in the OFF position
NORMAL - Safety grounded to chassis
(SW1 safety circuit)
NORMAL - Safety grounded to chassis
(SW2 safety circuit)
FAULT - Hinge communication fault
The stairlifts is failling to operate
the hinge section.
FAULT - Hinge end position not reached
The hinge section cannot get in line
with the rail or fully folded.
FAULT - Relay fault
Acorn Stairlifts User Manual
26

HARDWARE FAULT CODES

LIFT WILL NOT OPERATE

FATAL ERROR CODES

LIFT WILL NOT OPERATE
FATAL ERROR CODES continued on next page
• Activate the
directional toggle
switch and drive
the stairlift to a
charge point
• Check that the
key is in and
turned to the
ON position
4
• Check continuity
between every switch
in the SW1 or SW2
safety circuit and
chassis
•
Check that the mains
supply has not been
turned off or uplugged
from the wall.
•
Contact your authorized
Acorn dealer for
assistance
•
Check for obstructions
around the hinge
section.
•
Contact your
authorized Acorn
dealer for assistance
5
• Reset the stairlift
(power off
for 30 seconds)
• If not resolved,
contact your
authorized Acorn
dealer for
assistance