Trouble Shooting - Lamona LAM1761 User's Installation Manual

05 - Troubleshooting
If you encounter a problem, it is often something minor, please read some of the suggested tips below.
The hob produces a smell the first few times
it is used
Pans make a noise during cooking!!
The hob makes a slight clicking sound
The fan keeps working for a few minutes after the hob has been
turned off
The hob won't work. The indicators don't come on
The hob has turned itself off
Repairs
Error codes
Hob Status
Fault Description
Codes
U
H/C
C/P
H/c
H
Appliance Errors
Fault Description
& Alarms
F0
FA
FC
FE
Ft
If any of the above problems persist please contact the customer service line for further assistance,
Indicates no pan or suitable pan on
cook zone
Zone Over Temperature Product will
auto reset, Indicates pan overheat
Heater Over Temperature Product will
auto reset, Pan overheat
Induction Generator Over Temperature
Residual Heat
Software Error
Software Key Error
Software Key Error
Touch Ntc Error
Touch Ntc Error
This is normal - Heat a pan full of water on each zone for half an hour.
This is caused by vibration due to the passage of energy from the hob
to the pan. On a high setting this is quite normal for certain types of
saucepan. It will not damage the hob.
This is Normal - This is caused by the distribution of power between
two heating zones on the same side of the hob.
This is Normal - To cool down the electronics.
The electricity supply is not reaching the appliance (faulty supply or
connection); Check the fuses and the cut-out switch.
Refer to Troubleshooting chart and if problems persist call, the
customer service hot-line for further assistance.
Check that the main on/off switch has not been touched or covered
accidentally, remove any objects on the hob and try turning it back
on again.
Repairs are to be carried out by trained service technicians.
Action
Ensure correct pan size and that the pan is suitable for induction use
(Check with a magnet)
Allow hob to cool
Allow hob to cool
Check installation and free air flow to hob
" H" will switch off when glass surface drops below 60ºC
Action
Switch the power off and on, The system will reset and the hob should
now be working correctly
Switch the power off and on,The system will reset and the hob should
now be working correctly
Switch the power off and on, The system will reset and the hob should
now be working correctly
Switch the power off and on, The system will reset and the hob should
now be working correctly
Switch the power off and on, The system will reset and the hob should
now be working correctly
User manual LAM1761
_ 17
Troubleshooting