NEC SL 1000 Programming Manual page 120

SL1000/SL1100
Item
No.
09
10
11
Program
13
14
14
15
16
17
18
19
20
2-98
Downloaded from www.Manualslib.com
Item
Private Line
DTMF Tones for Outgoing
Calls
Use this option to enable (1) or
disable (0) DTMF tones for out-
going trunk calls.
Account Code Required
Trunk-to-Trunk Transfer
Use this option to enable (1) or
disable (0) loop supervision for
the trunk. This option is required
for Call Forwarding Off-Premise
and Tandem Trunking only.
Long Conversation Cutoff
Use this option to enable or dis-
able the Long Conversation Cut-
off feature for each trunk.
Long Conversation Alarm Be-
fore Cutoff
Use this option to enable or dis-
able the Long Conversation
Alarm for each trunk.
Forced Release of Held Call
Use this option to enable/disable
forced release for calls on Hold.
If enabled, the system discon-
nects a call if it is on Hold longer
than a programmed interval
(Program 24-01-05). If disabled,
forced disconnection does not
occur. Program 24-01-01 also
affects this option.
Trunk to Trunk Warning Tone
for Long Conversation Alarm
Use this option to enable or dis-
able the Warning Tone for Long
Conversation feature for DISA
callers.
Warning Beep Tone Signaling
Privacy Mode Toggle Option
Use this option to enable or dis-
able a trunk ability to be
switched from private to non-
private mode by pressing the
line key or Privacy Release func-
tion key.
Block Outgoing Caller ID
Allow (1) or prevent (0) the sys-
tem from automatically blocking
outgoing Caller ID information
when a user places a call. If al-
lowed (i.e. block, enabled), the
system automatically inserts the
Caller ID block code (defined in
14-01-21) before the user dialed
digits.
manuals search engine
Input Data Default
0 = Disable Private 0
Line (Normal)
1 = Enable Private
Line (Private Line)
0 = Disable (No) 1
1 = Enable (Yes)
0 = Disable (No) 1
1 = Enable (Yes)
0 = Disable (No) 0
1 = Enable (Yes)
0 = Disable (No) 0
1 = Enable (Yes)
0 = Disable (No) 0
1 = Enable (Yes)
0 = Disable (No) 0
1 = Enable (Yes)
0 = Disable (No) 0
1 = Enable (Yes)
0 = Disable (No) 0
1 = Enable (Yes)
0 = Disable (No) 0
1 = Enable (Yes)
0 = Prevent (No) 0
1 = Allow (Yes)
ISSUE 1.0
Related Program
Note
20-21-03
20-21-04
20-21-01
20-21-02
24-01-01
24-01-05
14-01-21
20-08-15
Program 14 : Trunk, Basic Setup