Examples - Siemens RX1400 Reference Manual

RUGGEDCOM NETCONF
Reference Guide

Examples

This section provides examples of how to set and retrieve data on a device. Each example shows how to set or
retrieve a specific element or set of elements. Each example also demonstrates a general NETCONF concept, such
as how to retrieve data from the running configuration, or how to use special attributes to delete or replace data.
Each example assumes that you are connected to a device and have established a NETCONF session. For
instructions on how to establish a NETCONF session,
Each example provides all of the <rpc> commands necessary to perform the function.
NETCONF Example
Section 7.1, "Getting the System Name"
Section 7.2, "Getting the ROX Release"
Section 7.3, "Getting the Chassis Status"
Section 7.4, "Setting the System Clock"
Section 7.5, "Acknowledging Alarms"
Section 7.6, "Clearing All Alarms"
Section 7.7, "Viewing Alarms"
Section 7.8, "Restoring Factory Defaults"
Section 7.9, "Changing the System Name by Locking and
Committing"
Section 7.10, "Changing the System Name Directly"
Section 7.11, "Creating a Static VLAN"
Section 7.12, "Assigning a PVID on a Port"
Section 7.13, "Disabling Spanning Tree on a Specific Port"
Section 7.14, "Configuring an IP Address on a Specific Port"
Section 7.15, "Deleting an IP Address"
Section 7.16, "Setting a Static Route"
Section 7.17, "Disabling Spanning Tree Globally"
Section 7.18, "Retrieving all IP Addresses from the Running
Configuration"
Section 7.19, "Retrieving the Active Routes on a Device"
Section 7.20, "Configuring Static Multicast Routing on a Layer 3
Device"
Section 7.21, "Enabling Static Multicast Routing on a Layer 3 Device"
seeChapter 3, NETCONF
Example demonstrates these techniques:
Querying for running configuration data.
Querying for fixed system data.
Querying for state information.
Using an action command.
Using an action command.
Using an action command.
Querying for state information.
Using an action command.
Recommended editing procedure.
Editing configuration data in the running configuration.
Recommended editing procedure.
Recommended editing procedure.
Recommended editing procedure.
Recommended editing procedure.
Recommended editing procedure.
Recommended editing procedure.
Recommended editing procedure.
Deleting data with the nc:operation="delete" attribute.
Recommended editing procedure.
Querying for running configuration data.
Recommended editing procedure.
Recommended editing procedure.
Sessions.
Chapter 7
Examples
77