GE IC695PNC001 User Manual page 120

7
SNMP Read Access
SNMP provides standard commands that allow a client to read SNMP data. The PNC supports all of
these commands.:

GET

GETNEXT

GETBULK
The SNMP Community strings supported for read access are:

public

pub

icmp

private

priv
These community strings are fixed and cannot be changed.
SNMP Write Access
SNMP should not be used to change parameters on the PNC module. The SNMP SET command
succeeds for the variables in some MIBs/groups, but fails for the variables in other MIBs/groups.
Changes made using SNMP SET only change the SNMP variable itself, do not affect the PNC
operation, and are not saved across a power-cycle or restart. For example, setting the sysName
variable from the System Group does not change the PNC's device name.
MIB-II Groups Supported
The PNC supports all of the mandatory values in the following groups of the MIB-II specification:

System group

Interfaces group

IP group

ICMP group

TCP group

UDP group

Transmission group (802.3 Ethernet subset)

SNMP group
The EGP group and Address Translation group of MIB-II are not supported.
PACSystems* RX3i PROFINET Controller Manual – December 2011
7-4 GFK-2571A