Deleting A Cdma Profile - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
Parameter
use-peer-dns
username
password
dial-on-demand
disconnect-idle-timeout
failover-on-demand
mtu
Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
7.
to proceed.
Click Exit Transaction or continue making changes.
8.
Section 5.13.1.3

Deleting a CDMA Profile

To delete a CDMA Profile, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
Navigate to global » cellular » profiles » cdma. The Cellular Network Configuration table appears.
2.
302
Description
Enables the DNS server entries that the PPP server recommends. Enables this option
unless you provide your own name servers.
Default: N/A
The user ID to connect to the remote server.
Default: N/A
The password to be authenticated by the remote server.
Activates dial-on-demand for this connection. The establishment of the PPP connection
is postponed until there is data to be transmitted via the interface. If dial-on-demand is
configured, Failover on Demand cannot be configured.
Prerequisite: If dial-on-demand is configured, Failover on Demand cannot be
configured.
Default: 0
The time in seconds to wait before disconnecting PPP when there is no traffic on the
link. This option is only valid when dial-on-demand is enabled.
Activates link failover on-demand on this device. PPP link establishment on this device
is controlled by link failover. If Failover on Demand is configured, Dial on Demand
cannot be configured.
Prerequisite: If link failover on-demand is configured, Dial on Demand cannot be
configured.
Default: 1500
MTU (Maximum Transmission Unit) value on a PPP interface.
RUGGEDCOM ROX II
User Guide
Deleting a CDMA Profile