Kenwood NX-5400 Service Manual page 57

Item Condition
Panel tuning
mode
16. 1) Adj item:
CWID [An CWID]
Devia- Adjust:[****]
tion *3 Deviation meter
LPF: 15kHz
[Analog HPF: OFF
Narrow] 2) Adj item:
[Frequency:
700MHz Band]
[RX/TA High]→
[TX High]
[Frequency:
800MHz Band]
[TX High]→
[RX/TA High]
Adjust:[****]
PTT : ON
Press [ ] key to
store the adjust-
ment value.
*3: Refer to the "4.9.1 Necessary Deviation adjustment item for each signaling and mode" table.
17. 1) Adj item:
Battery [BATT]
Warn- Adjust:[***]
ing PTT: ON
Level
writing
18. [Panel test mode]
Battery 1) CH-Sig: 1-1
Warn- BATT terminal
ing voltage: 6.0V
Level while transmitting
check
Measurement
PC test mode Test-
equip-
ment
1) Adj item: Devia-
[CWID Deviation tion
(Analog Narrow)] meter
Deviation meter Oscil-
LPF: 15kHz lo-
HPF: OFF scope
2) Adj item:
[Frequency:
700MHz Band]
[RX/TA High]→
[TX High]
[Frequency:
800MHz Band]
[TX High]→
[RX/TA High]
Press [Transmit]
button.
Press [Apply All]
button to store the
adjustment value.
1) Adj item: Power
[Battery Warning meter
Level] DVM
Press [Transmit]
button.
1)Test Channel
Channel: 1
Test Signaling
Mode: Analog
Signaling: 1
BATT terminal volt-
age: 6.0V while
transmitting
Unit Ter- Unit Parts
minal
Panel ANT Panel [Panel
tuning
mode]
[ ],
[ ]
[PC
test
mode]
[←],
[→]
Panel ANT
BATT
termi-
nal
Adjustment
Method
Write the value as fol- 1.00kHz±0.10
lowings. 513 (Reference kHz
value)
Press the PTT switch or
[Transmit] button on the
PC window. Apply 6.20V
to battery terminal. Con-
firm that one pre-deter-
mined numeric in the
range 1 to 256 appears.
[Panel tuning mode]
Press [ ] key to store
the adjustment value.
[PC test mode]
Press [Apply] button to
store the adjustment val-
ue.
Check The transceiv-
er can transmit
with causing
the LED to
blink.
(No.RA016<Rev.001>)1-57
Specifica-
tions
/Remarks