Onkyo TX-NR686 Instruction Manual page 105

Setting Item Default Value Setting Details
Auto Standby On/Off This setting allows the unit to enter standby mode
automatically after 20 minutes of inactivity without
any video or audio input. (When "USB Power Out
at Standby" or "Network Standby" is enabled, the
unit enters the HYBRID STANDBY mode which
minimizes the increase in power consumption.)
"On": The unit automatically enters standby mode
("AUTO STBY" lights up).
"Off": The unit does not automatically enter standby
mode.
• "Auto Standby" is displayed on the main unit's
• "Auto Standby" does not work when Zone 2 is
• Default values vary depending on the regions.
Auto Standby in Off Enable or disable "Auto Standby" while "HDMI
HDMI Standby Standby Through" is on.
Through "On": The setting is enabled.
"Off": The setting is disabled.
• This setting cannot be set to "On" if "Auto
USB Power Out Off When this function is set to "On", electricity can be
at Standby supplied to the device connected to the USB port
even if this unit is in standby mode .
• While using this function, power consumption
Contents
display and TV screen 30 seconds before
entering standby mode.
active.
Standby" and "HDMI Standby Through" are set
to "Off".
increases in standby mode, however, the
increase in power consumption is minimized by
automatically entering the HYBRID STANDBY
mode where only the essential circuits are
operating.
Connections
≫
Setting Item Default Value
Network Standby On
Bluetooth Wakeup Off
• Wait for a while if "Network Standby" and "Bluetooth Wakeup" cannot be selected. It can
be selected when the network function is activated.
105
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
Setting Details
When this function is set to "On", you can turn
on the power of the unit via network using an
application such as Onkyo Remote that can control
this unit.
• When "Network Standby" is used, power
consumption increases in standby mode,
however, the increase in power consumption is
minimized by automatically entering the HYBRID
STANDBY mode where only the essential circuits
are operating.
• When connection to the network is lost, "Network
Standby" may be disabled to reduce power
consumption. In such a case, turn the unit on by
using the power button on the remote controller
or main unit.
This function wakes up the unit on standby by
connecting a BLUETOOTH-enabled device.
"On": When this function is used
"Off": When this function is not used
• When this is set to "On", power consumption
increases in standby mode, however, the
increase in power consumption is minimized by
automatically entering the HYBRID STANDBY
mode where only the essential circuits are
operating.
• This setting is fixed to "Off" if "Bluetooth" - "Auto
Input Change" is set to "Off".
≫