SERVICE MANUAL
Model: WS49GDB
Error code
Part
EE
Temperature sens
LL
Compressor
HH
Compressor
F1
Temperature sens
Fault
Temperature sensor failure
(short circuit or open circuit)
The actual temperature of
the temperature sensor is less
than -5
The actual temperature of the
sensor is more than 50.
Not refrigeration in the box
Issue 2014-12-10
Rev.
FZ1412S025V3
Rrepair
1 Check the point of sensor,
and move it to original place.
2. Change the temperature
controller.
3. Put the wine cellar to suitable
place and make air circulate
well.
4.Remove frost regularly.
5. Check or supplement
refrigerant.
6. Change compressor.
7. Change new drying filter.
1. Check the point of sensor,
and move it to original place.
2. Adjust to suitable position,
normally contact tightly with
evaporator cover.
3. Change compressor.
1 Check the point of sensor,
and move it to original place.
2. Change the temperature
controller.
3. Put the wine cellar to suitable
place and make air circulate
well.
4.Remove frost regularly.
5. Check or supplement
refrigerant.
6. Change compressor.
7. Change new drying filter.
1.Vacuum pumping and Filling
refrigerant
2.Check the fan is ok or change
the compressor or
accessories of compressor
make air circulate well.
4.Remove frost regularly.
5. Check or supplement
refrigerant.
6. Change compressor.
7. Change new drying filter.
30
Need help?
Do you have a question about the WS49GDB and is the answer not in the manual?
Questions and answers
Wine cellar is not cooling for the white wine. The red wine section is working fine. Gaskets checked and they are fine
The Haier WS49GDB wine cellar may not be cooling the white wine section because it has a dual-zone temperature control system, and the temperature settings might not be properly adjusted. According to the manual, pressing the appropriate button sets the temperature for red or white wines. If the white wine section is not cooling, the user should check and adjust the temperature settings to ensure it is set between 7°C to 10°C for white wines. Additionally, it may take some time for the unit to reach the desired temperature.
This answer is automatically generated