Toro MULTI-PRO 1100 Operator's Manual

To assure maximum
performance, and to gain knowledge of the
product, it is essential that you or any other
operator of this Vehicle read and understand
the contents of this manual before the engine
is ever started. Pay particular attention to the
SAFETY INSTRUCTIONS highlighted by the
triangular safety alert symbol.
Keep this Operator's Manual in the plastic tube behind the operator seat.
It is very important that all persons operating this equipment have easy access to these instructions at
all times!
Carefully read and follow the "Set-Up" Instructions that are provided with this equipment and the Safety
Instructions in the Multi-Pro
RECOGNIZE SAFETY INFORMATION
This safety-alert symbol is used to call
attention to a dangerous situation, which
could result in serious injury or death to
the operator or a bystander.
Safety, mechanical
information in this manual are emphasized.
DANGER, WARNING and CAUTION identify
safety messages. Whenever the triangular safety
symbol appears, it is followed by a safety
message that must be read and understood. For
more details concerning safety, read the Safety
Instructions on this
IMPORTANT identifies
information and NOTE
information worthy of special attention.
These instructions are provided as a guide for the
safe operation and
equipment. However, the operator's personal
safety, as well as those persons in the work area,
will depend on the careful actions and good
judgement of the operator.
potential for injury or death, comply with the
following safety instructions.
BEFORE OPERATING:
1. Operate this machine equipped with this
ROPS only after reading and understanding the
contents of this manual and the Multi-Pro™ 1100
Operators Manual. A replacement manual is
available by sending complete model and serial
number to: Hahn Inc., 1625 N. Garvin,
Evansville, IN 47711.
Model No. 41185-90001 & UP
for the MULTI-PRO
safety, optimum

SAFETY INSTRUCTIONS

1100 Operator's Manual.
TM
and some general
page and page 2.
special mechanical
identifies general
maintenance of this
To reduce the
©The TORO Company - 1999
All Rights Reserved
OPERATOR'S, SET-UP ,
& PARTS MANUAL
ROPS
®
1100 Vehicle
The safety alert symbol means CAUTION,
WARNING or DANGER - personal safety
instruction. Failure to comply with the
instruction may result in personal injury.
2. Keep all safety devices and decals in place. If
a safety device or decal is malfunctioning, illegible
or damaged, replace it before operating the
machine.
3. It is mandatory to wear the seat belt at all times
when operating the machine equipped with the
ROPS system. (Always adjust and secure Seat
Belt before operating the machine.)
WHILE OPERATING:
1. Since this attachment adds extra weight to the
vehicle, drive safely and cautiously to prevent loss
of control and possible upset.
2. Gross vehicle weight has a major impact on
your ability to stop and/or turn. Heavier loads and
heavier attachments make a vehicle harder to stop
or turn. The heavier the load, the longer it takes to
stop.
3. The ROPS is equipped with a roll bar, shoulder
restraints and seat belt. The ROPS system used
on the vehicle will reduce the risk of serious or fatal
injury in the unlikely event of a tip over, although
the system cannot protect the operator from all
possible injuries.
4. Replace a damaged ROPS, do not repair or
revise. Any alteration of ROPS must be approved
by the manufacturer.
FORM NO. 92-3889
1