ABB COMMANDER 1900 Series User Manual page 16

• Totalization
...4 ADVANCED CONFIGURATION LEVEL
4.2 Set Up Totalizer
In this Section, parameters in the lower display denoted
programmed with these settings.
SEtUP
tOtALS
SELECt
NONE
tOt–1
tOt–2
tOt–3
tOt–4
NONE
tOtAL
ON
OFF
OFF
CNtdIr
UP
dN
SECUrE
tOtL 1
0000
0000
YES
SECrSt
NO
YES
NO
CNt–HI
1. 0 00
dEC–Pt
x. x xx
CNt–LO
0. 0 00
14
Page Header – Set Up Flow Totals
To advance to the
Set Up Maths
Select Totalizer
Select totalizer to be programmed.
Totalizer On/Off
ON OFF
Turn the totalizer or
the .
OPERATOR LEVEL
Count Direction
Select the count direction:
Up
– Incremental counter (
dN
– Decremental counter (
Secure Total
The secure flow total is independent of the
Use the switch to move the decimal point to the left or the
point to the right.
Secure Reset
The Secure Total may be reset to either
direction) if required. Select
Count Rate High
Set the required count rate (pulses/second) corresponding to input range high. This value is
programmable from 0.0 to 100.0 in 0.1 increments, 0.00 to 10.00 in 0.01 increments or from
0.000 to 1.000 in 0.001 increments, depending on the
following frame – see
Examples A
Count Rate Decimal Point
Set the decimal point position required for both
Count Rate Low
Set the required count rate corresponding to input range low, programmable from 0.0 to 100.0 in
0.1 increments, 0.00 to 10.00 in 0.01 increments or from 0.000 to 1.000 in 0.001 increments.
Continued on next page
are Company Standard Settings. The instrument is dispatched
page press the switch.
OFF
as required. If turned is selected the
Preset Value
Preset Value
OPERATOR LEVEL
00000000
YES to reset the counter or
Decimal Point
and previous page.
B,
Count Rate High
is omitted from
Totals Page
<
Predetermined Value)
>
Predetermined Value)
(batch) flow total in
switch to move the decimal
99999999
or (depending on the count
NO to retain the current counter value.
position programmed in the
and
Count Rate Low
.
.
Totals Page
.