Hdd Assist Mode (4C); Operation - Toshiba e-STUDIO477S Service Manual

3.10 HDD Assist Mode (4C)

3.10.1 General description
This mode is available only when the security HDD (ADI-HDD) is mounted in the equipment. It enables
you to check the type of the mounted HDD, revert the ADI-HDD to the factory default or remove keys.
Functions
• Checks the type (ADI or SATA) of the mounted HDD.
• Disposes of ADI-HDD data safely without any of leakage.
• Deletes image data when reusing a used ADI-HDD.
3.10.2 Operation procedure
[4][C]
[Digital Key]
[Power]
(Select)
[STOP]
Turn the power ON while pressing the [4] and the [CLEAR] button simultaneously. Then the type of the
mounted HDD is checked and either of the following screens is displayed.
• When the security HDD is mounted
HDD Assist Mode
Current HDD type: ADI HDD
Select number (1-2) and press START key
1. Revert factory initial status HDD
2. Remove key
© 2013-2016 TOSHIBA TEC CORPORATION All rights reserved
HDD data
[START] （

Operation

for SATA-HDD
Cancel
Fig. 3-7
3 - 19
[Power] OFF
）
clear
Failed
System Firmware Version : xxxx(x.x.x.x)
Update Mode : 4c Mode
e-STUDIO477S/527S/477SL
SELF-DIAGNOSTIC MODE
3