Copying An Application - ABB CP410 Installation And Operation Manual

Operation
7.8

Copying an Application

To copy an application from one CP410 to another CP410, select F8 - Copy
from the system menu. Set the dip switch SW7 = ON and connect the two op-
erator terminals with a download cable using COM2. After the self-test, the sys-
tem menu will be displayed on the screen.
Select F8 - Copy in the system menu from the operator terminal with the appli-
cation to be copied. The operator terminal will prompt for a password: enter the
password set in CP400Soft from Application/Workstation Setup. Once the cor-
rect password is entered, the CP410 starts to copy the application to the other
CP410.
For information about setting a password, please see section 7.9 Passwords.
The following appears on the screens during the copying:
Note:
When copying for the first time, make sure to first run the application once, or
else the copy function will not work.
ABB, 1SBC159101M0201 21