Table of Contents
Advertisement
Always push in an Emergency Stop Pushbutton whenever you observe an unsafe condition,
are clearing a board jam, are cleaning the machine, or are interacting with the i-BF in a non-
standard manner.
Safety Bumpers
The i-BF has (6) safety bumpers located on the moving gantry.
All of the safety bumpers are connected in series to a bumper safety relay (Tapeswitch
controller).
The bumper safety relay is part of the Emergency Stop Safety Circuit.
Pressing any of the safety bumpers will cause the i-BF to immediately emergency stop.
Gantry Uprights Safety Bumpers
Gantry Upper Frame Underside Safety Bumper
The i-BF has three Emergency Stop
pushbuttons located on the operator station
console and on each side of the machine
gantry.
When pressed, the Emergency Stop
pushbuttons are maintained in the inward
"safe" position and the i-BF safety circuit is de-
energized.
Safety bumpers are located on each side of
the moving gantry uprights to detect obstacles
in the forward or reverse direction of gantry
motion.
Kongsberg C-series
195
18
Advertisement
Table of Contents
Need help?
Do you have a question about the Kongsberg C series and is the answer not in the manual?
Questions and answers
how do I remove a blade from a presscut tool
To remove a blade from the Esko Kongsberg C series PressCut tool, use the special hand tool designed for this purpose. This tool helps in safely removing and inserting Knife Blades. Ensure that the blade is correctly positioned relative to the Alignment Pin when inserting a new one.
This answer is automatically generated