Table of Contents
Advertisement
Tool Adjustment
RotaCut is adjusted in the same way as the other C tools regarding rotation angle and offset.
Tool Height is manually adjusted:
Layer Setup for RotaCut
3
Observe the Guide Pin in the foot and the
groove in the Tool Shaft.
Position the foot onto the Tool Shaft as
shown at left.
Push the foot into position.
A self-locking mechanism ensures the foot is
kept in place.
Note: Be careful not to hit the sharp Knife
Blade.
4
Verify by hand that the foot movement is
smooth.
Tool Height for RotaCut is manually adjusted
using the tool height adjustment wizard
available from the Tool Configuration dialog.
Follow the instructions in the dialog.
Be careful, though, not to adjust the cutting
depth too deep into the Cutting Underlay
(figure at left).
U - cutting underlay
M - material
D - X/Y moving direction
Kongsberg C-series
139
12
Advertisement
Table of Contents
Need help?
Do you have a question about the Kongsberg C series and is the answer not in the manual?
Questions and answers
how do I remove a blade from a presscut tool
To remove a blade from the Esko Kongsberg C series PressCut tool, use the special hand tool designed for this purpose. This tool helps in safely removing and inserting Knife Blades. Ensure that the blade is correctly positioned relative to the Alignment Pin when inserting a new one.
This answer is automatically generated