Advertisement
(2) iIIILid" appears on the dsplay and procesl doe. not start.
1) Check the 2 shafts mounted
to the nd.
Push the shafts
to make sure that they slide In and out
smoothly.
Shafts
If
the shafts do not slide smoothly,
2)
Check the position
of
the both lock shah.
Lock
shafts
(1) Check the springs lItted to the shalls.
(2) Apply
grease
to
the
shaft sliding
perl
When the
cover
is opened,
(1) Check
if
the shalls are in due position
On just about vertical position).
(2) Check if the lock shafts open when pushlld outward and
they retum to the original position by spring force when
relaased.
If they can not move normally,
(1) Remove any foreign matter which
is
pinched and jams the
.hall
(2) Replace the spring,
etc.
If In trouble.
(3) Apply
grease to the
shaft sliding
perl
- 36-
Advertisement
