Fujitsu ARROWS NX F-01K Instruction Manual page 28

- Rapid temperature change may cause condensation. If you
bring the terminal from a cold place to warm place such as
a bathroom, wait until the terminal reaches the room
temperature.
◆ To ensure waterproofness/dustproofness
To prevent water or dust from entering the terminal, be sure
to observe the following points.
・
For installing/removing docomo nano UIM card or microSD
card, put your fingertip into the groove to open the slot cap
and then draw the slot cap in the direction of the arrow
horizontally and straight.
* When the slot cap is open, do not push the slot cap strongly
downward. May cause a damage of the slot cap.
Groove
・
After using, insert the slot cap in the direction of the arrow
straight, firmly press
between the terminal and the slot cap.
・
Make sure to firmly close the slot cap. Even a fine obstacle
(one hair, one grain of sand, tiny fiber, etc.) which is put
between contact surfaces may allow water or dust to enter.
・
Do not poke the stereo earphone jack, USB Type-C jack,
microphone, mouthpiece/microphone, speaker, back side
microphone, slot cap, etc. with a sharp object.
・
Do not let the terminal fall. Doing so may scratch the
terminal, causing its waterproof/dustproof performance to
degrade.
・
The rubber seal in the slot cap plays an important part in
waterproof/dustproof property. Do not damage or remove
the rubber seals. Also, prevent dust from adhering to them.
26
part. Make sure that there is no gap
Contents/Precautions