Advertisement
7) Select MAC address at
8) Enter IP Address, Subnet mask, Default Gateway according to your Sub environment.
- Caution:
There is no Gateway when the printer is connected to PC direct. Write the
Same with IP address at Gateway address.
- Notice:
Ethernet interface requests Gateway device to save its own IP address when
Data transmission does not take place for more than 5 minutes
9) Enter value at Local port.
(Default:
6000,
10) Set Baud rate.
(Set it as same as the printer condition. Highest bps can be used)
11) When setting finishes select "Setting".
12) Select
"Exit"
and finish the program.
NOTE 1.
"DHCP mode" is for
(DHCP: Dynamic Host Configuration Protocol)
NOTE 2. "Upload" button is used to upgrade Firmware.
V3.0.0
"Board
list".
choose from 6000 to 10000)
DHCP server.
www.samsungminiprinters.com
5
Advertisement
