Agilent Technologies E3647A User Manual page 6

Front-Panel Voltage and Current Limit Settings
You can set the voltage and current limit values from the front panel using the
following method.
1 Select the desired output and voltage range using the output selection keys
and voltage range selection keys after turning on the power supply.
2 Press
3 Move the blinking digit to the appropriate position using the resolution
selection keys and change the blinking digit value to the desired voltage limit
by turning the control knob. If the display limit times out, press
4 Set the knob to current control mode by pressing
5 Move the blinking digit to the appropriate position using the resolution
selection keys and change the blinking digit value to the desired current limit
by turning the control knob.
6 Press
go to output monitoring mode automatically to display the voltage and current
at the output.
N o t e All front panel keys and controls can be disabled with remote interface commands.
The power supply must be in "
function.
6
Use the voltage/current adjust selection key, the resolution selection keys,
and the control knob to change the voltage and current limit values.
1
Low
+ +
Or Or
2
High
Display key to show the limit values on the display.
Limit
Output key to enable the output. After about 5 seconds, the display will
On/Off
Voltage
Current
" mode for the front panel keys and controls to
Local
Display key again.
Limit
key.