Rs-232 Configuration - Agilent Technologies E3647A User Manual

Chapter 3 Front-Panel Operation and Features
Configuring the Remote Interface

RS-232 Configuration

I/O
Config 1 Turn on the remote configuration mode.
GPIB / 488
Notice that if you changed the remote interface selection to RS-232 before, "RS-232"
message is displayed.
2 Choose the RS-232 interface.
RS-232
You can choose the RS-232 interface by turning the knob.
I/O
Config 3 Select the baud rate
Select one of the following: 300, 600, 1200, 2400, 4800, or 9600 (factory setting)
baud.
9600 BAUD
I/O
Config 4 Select the parity and number of stop bits.
Select one of the following: None (8 data bits, factory setting), Odd (7 data bits), or
Even (7 data bits). When you set the parity, you are also indirectly setting the number
of the data bits.
NONE 8 BITS
I/O
Config 5 Save the change and exit the menu.
SAVED
3
51