fully Jarvis Assembly Instructions Manual page 19
Standing desk
Hide thumbs
Also See for Jarvis:
- Assembly instructions manual (26 pages) ,
- Quick start manual (9 pages) ,
- Assembly and use instructions (8 pages)
Table of Contents
Advertisement
Wide Assembly
step 9
Control Box
Slide the Control Box onto the Frame End with the
receiving Bracket.
Connect the cables from both Legs to the Control
Box via the sockets labeled M1 and M2.
Connect the Handset to the Control Box via the
socket labeled HS.
Connect the Power Cable via the power socket.
Cable management: Cable Clips work best adhered directly to the Jarvis metal
frame. Plus, it just looks cleaner. Route your power cord towards the side of your
Pro Tip:
nearest wall outlet, or, better yet, use a cable management tray for optimal cable
taming goodness.
Leg Cable
Power Cable
16
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Jarvis and is the answer not in the manual?
Questions and answers
I performed the reset and now my desk will not move at all when I press the controls
Your Fully Jarvis desk may not be moving after performing a reset due to one of the following reasons:
1. Lower Limit Restriction – If a lower height limit is set, the desk may not move beyond that point. You may need to restore default limits by pressing the M button, releasing it, and then pressing and holding it again until “555” appears on the display.
2. Reset Procedure Not Completed Properly – Some issues require a full reset where the legs retract completely. Ensure there is enough clearance below the desk to allow this.
3. Connection Issues – Even if the outlet works, double-check that all cables are securely connected and no wires are crimped or bent.
4. Handset Malfunction – If the up/down handset feels unresponsive, it may not be functioning properly. Try pressing and holding the buttons firmly.
If none of these steps work, contacting Fully customer service may be necessary.
This answer is automatically generated