Reset Master Code; Security Code Notes - Honeywell Lyric LCP300-L Installation And Reference Manual

Lyric Gateway Installation and Reference Guide

Reset Master Code

1. After Entering the Programming Mode, select "Users" from the Master User screen menu.
2. Select "Master" followed by "Edits' to reset the Master User Code.
3. Select "User Code".
4. Enter a new Master Code on the displayed keypad, then select "Done". The system returns to the previous
screen.
5. Select "Save"
6. If confirmed, the Master Code will be reset back to "1-2-3-4". This will be logged in the System Event Log as
"User: 1 Reset Master Code, E655".
Tools menu.
OR
If the reset failed, the system will display: "Command Failed. Unable to Reset Master Code". This will only
occur if the code 1-2-3-4 has been assigned to another User in the panel.
• The Master and Secondary security codes permit access to the system for arming, disarming,
etc.
• The Installer Code can disarm the system only if it was used to arm it. In addition, the Installer
Code cannot disarm the system if it was armed by pressing and holding a Quick-Arm button.
• The Guest Code can disarm the system only if it was used to arm it. In addition, the Guest Code
cannot disarm the system if it was armed by pressing and holding a Quick-Arm button.
• Duress code sends a special code to the Central Station when used to perform any system
operation. Instruct users to be careful not to use this code for normal usage.
• Opening/closing reports are sent for the Installer Code, with the appropriate subscriber
number. Master Code and secondary user codes are sent as User No. 2 and 3-48 respectively, in
Contact ID® format (with the appropriate user number).
Please inform the User about the security importance of their wireless key (key fob), and what to do
if it is lost.
Explain that the wireless key is similar to their keys or access card. If lost or stolen, another person
can compromise their security system. They should immediately notify the Dealer/Installer of a lost
or stolen wireless key. The Dealer/Installer will then remove the wireless key programming from the
security system.
The system returns to the second page of the Installer Programming

Security Code Notes

Important Security Notice
- 22 -
System Operation