Table of Contents
Advertisement
The Mobile Computer address should match the Mobile Computer IP Address
assigned on the Radio Configuration>Radio Wide>Data tab in Step 2 above.
4.
Double-click on Trunking ->Trunking System ->Trunking System 1.
a.
In the General tab, set the Type to ASTRO 25. If the proper system key was
loaded, the System Key field should already be enabled.
b.
Set the ASTRO 25 Home System ID, Home WACN ID and Unit ID to values
obtained from the radio system administrator.
c.
Under Coverage Type, set the type to SmartZone.
d.
In the Astro 25 Channel ID tab, enable the first channel.
e.
In the 700/800 Astro 25 Control Channels tab (700_800 or OBT depending on
the band), enter the control channels with which the data subscriber should be
able to affiliate. Consult your radio system administrator for the list of control
channels.
f.
In the Data tab, enable Packet Data Capable System (PDS), and Terminal Data
and disable (uncheck) Rx Voice Interrupts Data.
5.
Double-click on Trunking ->Trunking Personality ->Trunking Personality 1.
a.
In the General tab, set the Protocol Type to ASTRO 25 and set the System & ID
to 1.
b.
In the 700/800 Failsoft tab, data only subscribers should set Failsoft Type to
disabled. (There is no data service unless the subscriber is affiliated to a wide-
area trunking site.)
c.
In the Talkgroup tab, set the radio talkgroup value in hexadecimal. Consult your
radio system administrator for the talkgroup information.
d.
(Recommended) In the Preferred Sites tab, set the status of the first record to
None. (This means that data only subscribers are not locked into preferred sites.)
6.
Double-click on Zone Channel Assignment ->Zone Channel Assignment.
a.
In the Zone tab, set the Zone to the desired zone name (e.g. ZONE1).
b.
In the Channels tab, set the Channel to the name which will be displayed on the
radio screen (if the radio is Model II or III).
c.
Select the Personality type of that channel.
d.
Specify the Personality # of that channel.
e.
Specify the Talkgroup # of that channel.
7.
From the File Menu, select Save to save changes to the radio.
8.
From the File Menu, select Write Device to download the configuration to the radio.
21-25
Radio Types and Installation Kits
Advertisement
Table of Contents
