Crit-Line Screen - Fresenius Medical Care 2008T Operator's Manual
Hemodialysis machine
Hide thumbs
Also See for 2008T:
- Troubleshooting manual (769 pages) ,
- Operator's manual (370 pages) ,
- Calibration procedure (78 pages)
Table of Contents
Advertisement
Crit-Line Screen
Note: The 2008T hemodialysis machine is set up in Service Mode to display either the
"BTM BVM" screen or the "Crit-Line" screen. If the second to last screen-button along the
bottom of the display screen shows "BTM BVM" instead of "Crit-Line," turn to page 116.
Figure 54 – Crit-Line Screen (Showing BV and O
The Crit-Line in a Clip (CLiC) device is used to non-invasively measure a hemodialysis
patient's hematocrit, oxygen saturation and percent change in blood volume. These
measurements occur in real time in order to provide a more effective treatment. The
measurements are displayed on the 2008T hemodialysis machine's "Crit-Line" screen. Under
the direction of a physician, the clinician/nurse can increase or decrease the ultrafiltration
(UF) rate in order to remove the maximum amount of fluid without the patient experiencing
the common dialysis related complications which include hypotension, nausea, cramping and
vomiting.
The system consists of software for the 2008T hemodialysis machine, a Crit-Line in a Clip
(CLiC) device, a CLiC device-specific verification filter which is used to calibrate and verify
the CLiC device, and a disposable Crit-Line Blood Chamber. For more information, see the
2008T Hemodialysis Machine with CLiC User's Guide (P/N 490206).
2008T Machine Operator's Manual P/N 490122 Rev N
Chapter 4—Monitoring the Treatment
Saturation)
2
119
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the 2008T and is the answer not in the manual?
Questions and answers
Fresenius 2008 t machine with b bag options do the filters and o rings on the b bag need to be change on each annual pm and semiannual pm
What is the policy or steps if a Machine misses the weekly bleach by 1 day?
TMP low on t machine
A low TMP (Transmembrane Pressure) on a Fresenius Medical Care 2008T machine may indicate a potential issue with the balancing system or a possible leak. Adjusting TMP repeatedly can decrease the ultrafiltration (UF) removed from the patient. If TMP is rising, it should be investigated for leaks in the system.
This answer is automatically generated
WHAT IS A BIC PUMP
The Bic pump in the Fresenius Medical Care 2008T Hemodialysis Machine is used to manage the delivery of bicarbonate concentrate during treatment.
This answer is automatically generated