The Systemtools Commands - Cisco TelePresence DX70 Reference Manual

Cisco TelePresence DX70 and DX80

Introduction

The SystemTools commands

NOTE: The systemtools commands are used for
administrative control of the codec and are only available
from a command line interface. Systemtools should not be
used to program the codec.
Required parameters in angle brackets: <text>
Optional parameters in square brackets: [text]
To get an overview of the supported commands type
"systemtools ?".
Example:
systemtools ?
license
network
ntp
passwd
pki
rootsettings
securitysettings
securitystatus
selectsw
sudo
whoami
touch
To see the usage of the commands add a question mark after
the command.
Example:
systemtools network ?
usage: network ping <hostname> | traceroute
<hostname> | netstat | addrs | ifconfig
D15363.05 Cisco TelePresence DX70 and DX80 API Reference Guide CE9.2, NOVEMBER 2017.
About the API xConfiguration
systemtools license list
Lists all the licenses for the codec.
systemtools license show <name>
Shows the content of a license file, defined by the name.
<name>: The name of the license file.
systemtools network ping <hostname>
Network debug command.
<hostname>: The IP address or URL of the host.
systemtools network traceroute <hostname>
Network debug command.
<hostname>: The IP address or URL of the host.
systemtools network netstat
Network debug command.
systemtools network addrs
Check the systems IP address.
systemtools network ifconfig
Network debug command.
systemtools pairing unpair
Remove association with Cisco TelePresence Touch
controller.
systemtools passwd
Change the password for the logged in user.
systemtools pki list
Lists the codec certificate and CA list if they exist.
xCommand
systemtools pki delete <cert-name>
Delete the codec certificate and CA list if they exist.
systemtools securitysettings jitc
Set up security requirements so they meet JITC.
Set password and PIN polices enforced on the codec.
systemtools securitysettings isjitc
Check if the current settings are JTIC compiant.
systemtools securitysettings default
Revert to default security settings.
systemtools securitysettings ask
Query for the separate configurations. When issuing this
command you can see each policy separately.
•
•
•
Max failed login attempts [0]?
•
Suspend-time after max failed login attempts (minutes) [0]?
•
Max simultaneous sessions total [0]?
•
Max simultaneous sessions per user [0]?
•
198
API Reference Guide
xStatus Appendices Appendices
<cert-name>: The name of the certificate.
Press enter to keep the current value.
Enter a number and press enter to change the given
policy.
The default value "0" indicates no restrictions.
Number of failed logins until a user is set inactive.
Number of minutes the user is set inactive after maximum
failed login attempts have been exceeded.
Maximum number of users that can be logged in
simultaneous to web and maximum number of users that
can be logged in simultaneous to ssh/Telnet.
Maximum number of simultaneous sessions per user.
Copyright © 2017 Cisco Systems, Inc. All rights reserved.