Dnp Port Allocation - GE 345 Communications Manual

CHAPTER 1: COMMUNICATIONS GUIDE

DNP port allocation

345 TRANSFORMER PROTECTION SYSTEM – COMMUNICATIONS GUIDE
DNP 3.0 Device Profile
Default Counter Object/Variation:
□ No Counters Reported
□ Configurable (attach explanation)
⊠ Default Object: 20
Default Variation: 1
⊠ Point-by-point list attached
Sends Multi-Fragment Responses:
⊠ Yes
□ No
Channel 1 Port Channel 2 Port
None None
None NETWORK-TCP
None NETWORK-UDP
NETWORK-TCP None
NETWORK-TCP NETWORK-TCP
NETWORK-TCP NETWORK-UDP
NETWORK-UDP None
NETWORK-UDP NETWORK-TCP
NETWORK-UDP NETWORK-UDP
The DNP Eth Channel 1 Port and DNP Eth Channel 2 Port settings select the
communications port assigned to the DNP protocol for each Ethernet channel. When this
setting is set to "Network-TCP" the DNP protocol can be used over TCP/IP channels 1 or 2.
When this value is set to "Network-UDP" the DNP protocol can be used over UDP/IP on one
channel only.
Counters Roll Over at:
□ No Counters Reported
□ Configurable (attach explanation)
⊠ 16 Bits
□ Other Value: _____
⊠ Point-by-point list attached
DNP Availability
DNP not available over Ethernet port
One Master over TCP
"Various" Masters over UDP
One Master over TCP
Two Masters over TCP
One Master over TCP and "various" Masters over UDP
"Various" Masters over UDP
"Various" Masters over UDP and one Master over TCP
"Various" Masters over UDP
ETHERNET INTERFACE
1–41