Installing And Configuring A Samsung Repeater (Wrfp) - Samsung DECT 500 Installation And Programming Manual

Part 2: DECT Hardware Installation and Programming
Installing and Configuring a Samsung
Repeater (WRFP)
A.
You will need the Repeater / Handset Programming Tool running on a PC connected
to the DECT system and documentation on how to connect the cables.
1. Pull the wire from the power supply through the wall holder and then mount
the wall holder on the wall.
2. Connect the wire to the plug on the back of the Repeater and "click" the
WRFP onto the wall holder.
If you need to remove the Repeater, separate it from the wall holder with a gentle
push of a screwdriver.
To configure the Repeater, run the Repeater / Handset Programming Tool.
Although Repeaters look similar for both the
500 and the 1500 system, they are not inter-
changeable. Do not attempt to use a Repeater
intended for a 500 system on a 1500 system, or
vice versa.
To install a Samsung Repeater, it is recom-
mended you use the instructions in part A. If
you do not have access to the Repeater / Hand-
set Programming Tool (PN 13821) and a PC, use
the instructions in part B.
38