Table of Contents
Advertisement
1. Description
This unit is a pump that will clear the waste from a shower and washbasin, bath, washing machine, glass washer and a sink in a light commercial
situation.
The unit will start automatically.
Please pay particular attention to the following:
Possible danger to personnel
"ATTENTION" This is a general warning that failure to follow instructions could result in poor functioning of the unit.
This equipment benefits from the latest technological innovations concerning soundproofing. To benefit fully from the advantages provided by
this new generation of appliances, it is important to comply with the installation instructions in section 5.
2. List of Accessories included
A
Rubber connector
E
25 x 40mm
Metal hose clip
I
Floor mounting bracket
x3
B
Discharge elbow
x1
F
40 x 60mm
Metal hose clip
x2
Warning of possible electrical hazard
x1
C
End cap
x1
G
Metal hose clip
x2
D
Air vent cover
x6
H
32 x 50mm
Floor mounting screws
x1
x2
Advertisement
Table of Contents
Related Manuals for Saniflo SANISPEED
Summary of Contents for Saniflo SANISPEED
- Page 1 1. Description This unit is a pump that will clear the waste from a shower and washbasin, bath, washing machine, glass washer and a sink in a light commercial situation. The unit will start automatically. Please pay particular attention to the following: Possible danger to personnel Warning of possible electrical hazard “ATTENTION”...
- Page 2 92.5 mm ø 309 mm 139.4 mm 4. Performance Curve & Height and Length of the discharge pipe ø The discharge pipe size for Sanispeed must be 32mm. Flow Rate L/min max 10m Max 7m max 20m max 30m max 40m...
- Page 3 5. Installation The unit should be accessible for possible maintenance. It is supplied with floor fixing lugs to prevent it from moving during use. If pumping vertically, always put the vertical before the horizontal at the start of the piperun. 6.
- Page 4 8. Connection of bathroom appliances To connect a shower/bath, ensure that the trap exit is 15cm above floor level. Although not obligatory, a lid connection may be used to run an external air vent. 9. Discharge connection Note: The discharge pipework should be 32mm copper or rigid solvent weld plastic.
- Page 5 220 - 240 V - 50 Hz - 400 W - IP44 2A - 6,4 KG 13. Care and use The Sanispeed is designed to handle the waste evacuation from a bath, kitchen sink, dishwasher and washing machine - in a light commercial situation. Its powerful pump will deal with every day normal usage.
- Page 6 16. Parts...
Need help?
Do you have a question about the SANISPEED and is the answer not in the manual?
Questions and answers