6.3 To install the Network/ Power Unit
Nokia RoofTop™ Wireless Router Installation Guide
1.
Trim back the multiwire cable insulation taking care not to cut any of
the smaller wires in the cable.
2.
Remove the Network/Power Unit from its' packaging and loosen the
strain relief (the unit is already disassembled).
3.
Place the cable through the strain relief and slot the appropriate wire
into the appropriate slot in the connection. Using the punch down
tool, fix the wire into the Network/ Power Unit.
4.
When all wires are connected securely, reconnect the cable strain
relief in the unit to prevent the multiwire cable from being pulled out
of the unit.
5.
Replace the Network/Power Unit cover and replace the screws. Do
not overtighten the screws.
6.
Plug the Network/Power Unit into the wall AC outlet. The LEDs on
the unit should flash three times to indicate that the unit is connected
to the router.
To install the Network/ Power Unit
35