INSTALLATION/CONNECTION
Basic procedure
1 Remove the key from the ignition switch, then disconnect the [
terminal of the car battery.
2 Connect the wires properly.
See Wiring connection. ( 33)
3 Install the unit to your car.
See Installing the unit (in-dash mounting).
4 Connect the [ terminal of the car battery.
5 Press
to turn on the power.
6 Reset the unit. ( 3)
Part list for installation
(A) Trim plate (only
(B) Wiring harness
for Toyota car)
(C) Round head screws
(D) Flat head screws
(M5 × 8 mm)
Use only the specified screws. Using
wrong screws might damage the unit.
32
ENGLISH
Installing the unit (in-dash mounting)
Install onto the car brackets using the supplied screws (C) or (D). The screw holes differ depending on the
model of the cars.
Installing in Toyota cars
Install onto the car brackets using the supplied screws (C) or (D). Use the mounting holes (
the car brackets. Then, install the supplied trim plate (A).
Do the required wiring.
( 33)
(M5 × 8 mm)
Do the required wiring.
( 33)
Dashboard of your car
Dashboard of your car
Car bracket
) or (
) that fit
Car bracket