Installing The Heatsink - HP Netserver LP2000r Service Manual

Chapter 6
NOTE
8. Align the second processor over the empty processor socket.
CAUTION
9. Insert the second processor into the socket and close the ZIF lever to fully seat the processor.
You should hear the ZIF lever click when it closes properly.
NOTE

Installing the Heatsink

After installing a new processor, you need to install a heatsink on top of the processor. The thermal patch on
the bottom of the heatsink provides thermal bonding between the two components. The patch must be
replaced if the heatsink is removed (even temporarily) from the processor.
1. Remove the heatsink from the shipping container.
86
Keep the terminator for future use. The terminator must be installed in the
secondary processor socket when only one processor is used, or the HP Netserver
will not operate properly.
Ensure that you align pin-1 of the processor with pin-1 of the processor socket, or
pin damage will occur.
No speed switch settings are required for the supported 866 MHz, 933 MHz, or
1GHz processors. These processors rely on their own internal switch settings, and
not on system board switch settings.
Installing the Processor on the System Board
Replacing Parts
Pin 1
Marker