Setup; Installing Software; Installing Hp Designjet 3D Software Solution; Installing Firmware To The Workstation - HP Designjet 3D Service Manual

Set up the printer and material bay(s) per assembly instructions included with
printer.

Installing software

There are two software programs that work with HP Designjet 3D and HP
Designjet Color 3D:
1. HP Designjet 3D Software Solution, installed on your workstation,
processes the STL files for printing and communicates with the printer
from your workstation.
2. System firmware, the operating software installed on the printer, controls
printer functions.

Installing HP Designjet 3D Software Solution:

1. Locate the Startup DVD from startup kit and insert into workstation (PC).
2. Click the Install HP Designjet 3D Software Solution: button.
3. Follow prompts to finish loading HP Designjet 3D Software Solution on
the workstation.

Installing firmware to the workstation:

1. Click the Install Firmware button to load firmware to your workstation.
You will be asked to load this firmware to your printer later.
2. Follow prompts to finish installing firmware on the workstation.
3. Install firmware to the printer, see
page 30.

Networking the printer

There are two methods of connecting your printer to your workstation, over a
network or with a direct connection to your workstation.

Connecting through a network:

1. Locate the network cable (blue) from the startup kit.
2. Connect the network cable between the printer and the network hub.

Connecting directly to a workstation:

1. Locate the crossover cable (orange) from the startup kit.
2. Connect the crossover cable between the printer and the network port
on your workstation.

Setup

"Installing Firmware on printer" on
-25