Table of Contents Table of Contents ................. 2 Important Safeguards ..............3-4 Placement and Installation ............5-6 Parts List ..................6-7 Control Panel ................8 Remote Control ................9 Operation Methods ................ 9-10 Water Drainage ................11 Maintenance ................. 12 Troubleshooting……………………………………………………….13 Technical Data…………………………………………………………14 Circuit Diagram ...…………………………………..….…..
• If the power cord is damaged it must be repaired by an authorized agent of Omega Altise SAFETY RULES To prevent injury to the user or other people and to prevent property damage, the following instructions must be followed. Incorrect operation due to not reading the instructions may cause harm or damage.
Page 4
• Always contact an authorized qualified service agent to carry out repairs. • If the supply cord is damaged it must be repaired by a qualified repairer • Keep the area clear around the air conditioner. There needs to be an air path of a Minimum of 50cm all around the air conditioner from walls, furniture and curtains.
Placement and Installation Placement Place the on flat and dry ground, and keep at least 50 cm from walls etc. (figure 1) Installation • Spin slide bar connector into exhaust hose first, then spin the exhaust hose into exhaust connector (counter-clockwise). •...
Page 6
FIGURE 2 FIGURE 3 Warning Use only the exhaust pipe supplied. Longer or extended pipes may damage the appliance Note: maximum length of unfolding exhaust pipe is 1500mm, please shorten the length as much as possible and keep it level as much as possible when installing...
Control Panel Operation POWER: press this key to turn air conditioner On or Off. After air conditioner turns on, default value is Auto mode with medium fan speed. OPERATION MODE BUTTON: after air conditioner turns on, for auto mode, press this key to select the other modes: Fan, Dry/dehumidify, Cool or Auto.
Remote Control Operation Methods Auto Mode According to the current room temperature, once you select AUTO it automatically selects the relevant mode. Cooling Mode • After air conditioner turns on, the air conditioner will revert to setting that was last used. •...
Page 10
Timer Mode • When in off/ standby, press "TIMER" to setup the power-on timer, press "UP or "DOWN" to adjust the timer (from 1-24 hours) press "TIMER" to confirm selection. • "Under power-on mode, press "TIMER" to setup power-off, Press "UP or "DOWN"...
Water Drainage This air conditioner has an auto-water-evaporating system. Condensed- water cycle is used to cool down the condenser, which not only improves cooling efficiency, but also saves energy. If inner water tank is full, ”W.F” indicator will light on the screen, after 5 minutes the compressor stops working.
Maintenance Note: in order to avoid electric shocks, please turn off at the control panel, switch off the power point then unplug the appliance before cleaning Cleaning • Please switch off at the control panel, then at the power point then unplug before cleaning.
Seasonal Cleaning If the air conditioner is not being used for a long time, please follow these steps. • Pull out drainage plug upper / lower to empty any water out. • Let the air conditioner run under fan mode for 2 hours to dry out the air conditioner internals •...
Technical Data Model OAPC167 BTU/h Cooling capacity 16000 Mains Power consumption 1800 Current Refrigerant R410A Rotary Compressor Fan speeds ℃ Thermostat 16-31 Timer 0-24 47 x 76.4 x 37 Dimensions(W*H*D) Gross Weight...
Page 16
Omega Altise air conditioners are distributed in Australia by Shriro Australia Pty Ltd. Locked Bag 5002, Kingsgrove NSW 2208 Phone: 1300 795 572 Fax: (02) 9415 5525 Web: http://www.omegaaltise.com.au...
Need help?
Do you have a question about the OAPC167 and is the answer not in the manual?
Questions and answers