Yamaha FJR13AEV(C) Service Manual page 699

Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
• Positive tester probe →
yellow/green "1"
• Negative tester probe →
black/blue "2"
c. Turn the main switch to "ON".
d. Turn the lean angle sensor to 65°.
e. Measure the lean angle sensor output volt-
age.
L LLL L LLL L L LLL L L LLL L
ET3P61016
CHECKING THE STARTER MOTOR
OPERATION
1. Check:
• Starter motor operation
Does not operate → Perform the electric
starting system troubleshooting, starting with
step 4.
Refer to "TROUBLESHOOTING (FJR13A)"
on page 8-23 and "TROUBLESHOOTING
(FJR13AE)" on page 8-25.
M MMM M MMM M M MMM M M MMM M
a. Connect the positive battery terminal "1" and
starter motor lead "2" with a jumper lead "3".
EWA13810
WARNING
• A wire that is used as a jumper lead must
have at least the same capacity of the bat-
tery lead, otherwise the jumper lead may
burn.
• This check is likely to produce sparks,
therefore, make sure no flammable gas or
fluid is in the vicinity.
L LLL L L LLL L LLL
M MMM M M MMM M MMM
8-228
ELECTRICAL COMPONENTS
b. Check the starter motor operation.
L LLL L LLL L L LLL L L LLL L
EAS28150
CHECKING THE STATOR COIL
1. Disconnect:
• Stator coil coupler
(from the wire harness)
2. Check:
• Stator coil resistance
Out of specification → Replace the stator coil.
Stator coil resistance
0.13–0.19 Ω at 20 °C (68 °F)
M MMM M MMM M M MMM M M MMM M
a. Connect the pocket tester (Ω × 1) to the stator
coil coupler as shown.
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
• Positive tester probe →
white "1"
• Negative tester probe →
white "2"
• Positive tester probe →
white "1"
• Negative tester probe →
white "3"
• Positive tester probe →
white "2"
• Negative tester probe →
white "3"
L LLL L L LLL L LLL
M MMM M M MMM M MMM